Document Type: Original Article
Babol Noshirvani University of Technology
Babol Noshirvani University of technology
University of Mazandaran
This paper proposes a pulsed power generator which consists of two types of switched-capacitor booster modules with reduced number of power electronics and other passive elements. A doubling mode module employed to elevate the input voltage to a specified level and, constant mode module is used to increase the elevated voltage into the finally intended bipolar output voltage. It can be a good option for the applications with low input voltage and high output voltage requirements. Also, the proposed modular structure does not utilize any switches across the load. Other advantage of the proposed structure is its lower current stress on source and every circuit component near it. In comparison with Marx Generator (MG) based topologies, the number of circuit components has been significantly reduced, which led to cost-saving and prevention of circuit control complexity. Calculation of the capacitors has been presented. Experimental tests and simulations are performed on a five-module system which confirms the high performance of the proposed topology.