1. Richter, C., Lincot, D. and Gueymard, C.A., "Solar energy, New york, Springer, (2013).
2. Garg, H. and Adhikari, R., "Performance evaluation of a single solar air heater with n‐subcollectors connected in different combinations", International Journal of Energy Research, Vol. 23, No. 5, (1999), 403-414.
3. Belusko, M., Saman, W. and Bruno, F., "Performance of jet impingement in unglazed air collectors", Solar Energy, Vol. 82, No. 5, (2008), 389-398.
4. Duffie, J.A. and Beckman, W.A., "Solar engineering of thermal processes", New York, 2th Edn. Wiley, (1980).
5. Koyuncu, T., "Performance of various design of solar air heaters for crop drying applications", Renewable Energy, Vol. 31, No. 7, (2006), 1073-1088.
6. Ratti, C. and Mujumdar, A., "Solar drying of foods: Modeling and numerical simulation", Solar Energy, Vol. 60, No. 3-4, (1997), 151-157.
7. Khamforoush, M., Mirfatah, S. and Hatami, T., "Application of three types of dryers namely tunnel, fluidized bed, and fluidized bed with microwave for drying of celery, corn, and sour cherry: Experiments and modeling", International Journal of Engineering-Transactions B: Applications, Vol. 27, No. 5, (2014), 667.
8. Yeh, H.-M. and Lin, T.-T., "The effect of collector aspect ratio on the collector efficiency of flat-plate solar air heaters", Energy, Vol. 20, No. 10, (1995), 1041-1047.
9. Chabane, F., Moummi, N., Bensahal, D. and Brima, A., "Heat transfer coefficient and thermal losses of solar collector and nusselt number correlation for rectangular solar air heater duct with longitudinal fins hold under the absorber plate", Applied Solar Energy, Vol. 50, No. 1, (2014), 19-26.
10. Ghasemi, S., Hatami, M. and Ganji, D., "Analytical thermal analysis of air-heating solar collectors", Journal of Mechanical Science and Technology, Vol. 27, No. 11, (2013), 3525-3530.
11. Karim, M.A. and Hawlader, M., "Performance investigation of flat plate, v-corrugated and finned air collectors", Energy, Vol. 31, No. 4, (2006), 452-470.
12. Nowzari, R., Aldabbagh, L. and Egelioglu, F., "Single and double pass solar air heaters with partially perforated cover and packed mesh", Energy, Vol. 73, (2014), 694-702.
13. Kumar, S. and Saini, R., "Cfd based performance analysis of a solar air heater duct provided with artificial roughness", Renewable Energy, Vol. 34, No. 5, (2009), 1285-1291.
14. Idlimam, A., "Etude théorique d’un système de séchage des peaux et des cuirs pour la région de marrakech constitué d’une serre agricole jouant le rôle de générateur solaire d’air chaud et d’un séchoir conventionnel’", These de 3eme cycle, Ecole Normale Supérieure, Marrakech, Maroc, (1990).
15. Ajay, K. and Kundan, L., "Performance evaluation of nanofluid (al2o3/h2o-c2h6o2) based parabolic solar collector using both experimental and cfd techniques", International Journal of Engineering-Transactions A: Basics, Vol. 29, No. 4, (2016), 572.
16. Kays, W.M., "Convective heat and mass transfer, Tata McGraw-Hill Education, (2012).
17. Youcef‐Ali, S. and Desmons, J., "Simulation of a new concept of an indirect solar dryer equipped with offset rectangular plate fin absorber‐plate", International journal of energy research, Vol. 29, No. 4, (2005), 317-334.
18. Chabane, F., "Modélisation des paramètres de la conversion thermique de l'énergie solaire", Université Mohamed Khider-Biskra, Applied Solar Energy, Vol. 50, No. 1, (2014), 19-26.
19. Kasaeian, A., Mobarakeh, M.D., Golzari, S. and Akhlaghi, M., "Energy and exergy analysis of air PV/T collector of forced convection with and without glass cover", International Journal of Engineering-Transactions B: Applications, Vol. 26, No. 8, (2013), 913.
20. Klein, S. and Beckman, W., "A general design method for closed-loop solar energy systems", Solar Energy, Vol. 22, No. 3, (1979), 269-282.
21. Goudarzi, K., Asadi, Y.A.S., Shojaeizadeh, E. and Hajipour, A., "Experimental investigation of thermal performance in an advanced solar collector with helical tube", International Journal of Engineering, Transaction A: Basics, Vol. 27, No. 7, (2014), 1149-1154